Set Radius Server - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Access:
Usage:
Enter a separate command for each SSID, and its tag value, you want the switch to support.
Examples:
DWS-1008# set radius proxy port 3-4 tag 104 ssid mycorp
success: change accepted.

set radius server

Configures RADIUS servers and their parameters. By default, the switch automatically sets
all these values except the password (key).
Syntax: set radius server server-name [address ip-address] [auth-port port-number]
[acct-port port-number] [timeout seconds] [retransmit number] [deadtime minutes] [key
string] [author-password password]
servername
address
ipaddress
authport
portnumber
acctport
portnumber
timeout seconds Number of seconds the switch waits for the
retransmit
number
deadtime minutes Number of minutes the switch waits after
D-Link Systems, Inc.
Enabled.
AAA for third-party AP users has additional configuration requirements.
The following command maps SSID mycorp to packets received on port 3 or
4, using 802.1Q tag value 104:
Unique name for this RADIUS server. Enter an
alphanumeric string of up to 32 characters, with
no blanks.
IP address of the RADIUS server. Enter the
address in dotted decimal notation.
UDP port that the switch uses for authentication
and authorization.
UDP port that the switch uses for accounting.
RADIUS server to respond before retransmitting.
You can specify from 1 to 65,535 seconds.
Number of transmission attempts made before
declaring an unresponsive RADIUS server
unavailable. You can specify from 1 to 100 retries.
declaring an unresponsive RADIUS server
unavailable before retrying that RADIUS server.
Specify between 0 (zero) and 1440 minutes
(24 hours). A zero value causes the switch to
identify unresponsive servers as available.
RADIUS Commands
307