System Log Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use the system log commands to record information for monitoring and troubleshooting.
MSS system logs are based on RFC 3164, which defines the log protocol.
clear log
Clears the log messages stored in the log buffer, or removes the configuration for a syslog
server and stops sending log messages to that server.
Syntax: clear log [buffer | server ip-addr]
buffer
server ip-addr
Defaults: None.
Access: Enabled.
Examples: To stop sending system logging messages to a server at 192.168.253.11, type
DWS-1008# clear log server 192.168.253.11
success: change accepted.
Type the following command to clear all messages from the log buffer:
DWS-1008# clear log buffer
success: change accepted.
set log
Enables or disables logging of DWS-1008 and AP events to the switch log buffer or other
logging destination and sets the level of the events logged. For logging to a syslog server
only, you can also set the facility logged.
D-Link Systems, Inc.

System Log Commands

Deletes the log messages stored in nonvolatile
storage.
Deletes the configuration for and stops sending
log messages to the syslog server at this IP
address. Specify an address in dotted decimal
notation.
the following command:
System Log Commands
380