D-Link DWS-1008 Cli Reference Manual page 39

DWS-1008 CLI Reference Guide
set port type ap (continued)
The following command sets ports 4 through 6 for the DWL-8220AP and enables PoE on the
ports:
DWS-1008# set port type ap 4-6 model dwl-8220ap poe enable
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
The following command sets port 1 for the DWL-8220AP, enables PoE on the port, and sets
the radio type to 802.11b only:
DWS-1008# set port type ap 1 model dwl-8220ap poe enable radiotype 11b
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
The following command resets port 5 by clearing it:
DWS-1008# clear port type 5
This may disrupt currently authenticated users. Are you sure? (y/n) [n]y
success: change accepted.
set port type wired-auth
Configures a DWS-1008 switch port for a wired authentication user.
Note: Before changing the port type from ap to wired-auth or from wired-auth to ap, you must
reset the port with the clear port type command.
Syntax: set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none}]
port-list
tag-list
num
last-resort
none
D-Link Systems, Inc.
List of physical ports.
One or more numbers between 1 and 4094 that subdivide a wired
authentication port into virtual ports.
Maximum number of simultaneous user sessions supported.
Automatically authenticates the user, without requiring a username and
password.
Denies authentication and prohibits the user from accessing the network over
this port.
Port Commands
38