D-Link DWS-1008 Cli Reference Manual page 221

DWS-1008 CLI Reference Guide
show auto-tune neighbors
Displays the other D-Link radios and third-party 802.11 radios that a D-Link radio can hear.
Syntax:
[radio {1 | 2| all}]]
Syntax:
[radio {1 | 2| all}]]
ap-num
dap-num
radio 1
radio 2
radio all
Defaults:
Access:
Usage:
Examples:
DWS-1008# show auto-tune neighbors ap 2 radio 1
Total number of entries for port 2 radio 1: 5
Channel Neighbor BSS/MAC
-----------------------------------------------------------------------------------------------------------------------
1 00:0b:85:06:e3:60
1 00:0b:0e:00:0a:80
1 00:0b:0e:00:d2:c0
1 00:0b:85:06:dd:00
1 00:0b:0e:00:05:c1
The table describes the fields in this display.
D-Link Systems, Inc.
show auto-tune neighbors [ap ap-num
show auto-tune neighbors [dap dap-num
AP port connected to the DWL-8220AP access point for which to
display neighbors.
Number of a Distributed AP for which to display neighbors.
Shows neighbor information for radio 1.
Shows neighbor information for radio 2. (This option does not apply to
single-radio models.)
Shows neighbor information for both radios.
None.
Enabled.
For simplicity, this command displays a single entry for each D-Link radio,
even if the radio is supporting multiple BSSIDs. However, BSSIDs for
third-party 802.11 radios are listed separately, even if a radio is supporting
more than one BSSID.
Information is displayed for a radio if the radio sends beacon frames or
responds to probe requests. Even if a radio's SSIDs are unadvertised,
D-Link radios detect the empty beacon frames (beacon frames without
SSIDs) sent by the radio, and include the radio in the neighbor list.
The following command displays neighbor information for radio 1 on the
directly connected DWL-8220AP access point on port 2:
RSSI
-46
-78
-74
-50
-72
Access Point Commands
220