D-Link DWS-1008 Cli Reference Manual page 40

DWS-1008 CLI Reference Guide
set port type wired-auth (continued)
Defaults: The default tag-list is null (no tag values). The default number of sessions is 1.
The default fallthru authentication type is none.
Access: Enabled
Usage: You cannot set a port's type if the port is a member of a port VLAN. To remove a
port from a VLAN, use the clear vlan command. To reset a port as a network port,
use the clear port type command.
When you change port type, MSS applies default settings appropriate for the port type. The
table below lists the default settings that MSS applies when you set a port's type to ap.
Port Parameter
VLAN membership
Spanning Tree Protocol (STP)
802.1X
Port groups
IGMP snooping
Maximum user sessions
Fallthru authentication type
Examples: The following command sets port 2 for a wired authentication user:
DWS-1008# set port type wired-auth 2
success: change accepted
The following command sets port 5 for a wired authentication user and subdivides the port
into three virtual ports to support three simultaneous user sessions:
DWS-1008# set port type wired-auth 5 1,2,3
success: change accepted
D-Link Systems, Inc.
Setting
Removed from all VLANs.You cannot assign an AP access
port to a VLAN. MSS automatically assigns AP access
ports to VLANs based on user traffic.
Not applicable
Uses authentication parameters configured for users.
Not applicable
Enabled as users are authenticated and join VLANs.
1 (one)
None
Port Commands
39