D-Link DWS-1008 Cli Reference Manual page 196

DWS-1008 CLI Reference Guide
none
Defaults:
Access:
Usage:
Examples:
DWS-1008# set service-profile rnd_lab auth-fallthru none
success: change accepted.
set service-profile auth-psk
Enables preshared key (PSK) authentication of Wi-Fi Protected Access (WPA) clients by
DWL-8220AP radios in a radio profile, when the WPA information element (IE) is enabled in
the service profile.
Syntax:
name
disable
Defaults:
Access:
Usage:
Examples:
DWS-1008# set service-profile wpa_clients auth-psk enable
success: change accepted.
D-Link Systems, Inc.
Denies authentication and prohibits the user from accessing the SSID.
Note: The fallthru authentication type none is different from the uthentication
method none you can specify for administrative access. The fallthru
authentication type none denies access to a network user. In contrast, the
authentication method none allows access to the switch by an administrator.
The default fallthru authentication type is none.
Enabled
The last-resort fallthru authentication type allows any user to access any
SSID managed by the service profile. This method does not require the user
to provide a username or password. Use the last-resort method only if none
of the SSIDs managed by the service profile require secure access.
The following command sets the fallthru authentication for SSIDS managed
by the service profile rnd_lab to none:
set service-profile name auth-psk {enable | disable}
Service profile name. enable Enables PSK authentication of WPA clients.
Disables PSK authentication of WPA clients.
When the WPA IE is enabled, PSK authentication of WPA clients is enabled
by default. If the WPA IE is disabled, the auth-psk setting has no effect.
Enabled
This command affects authentication of WPA clients only. To use PSK
authentication, you also must configure a passphrase or key. In addition, you
must enable the WPA IE.
The following command enables PSK authentication for service profile
wpa_clients:
Access Point Commands
195