D-Link DWS-1008 Cli Reference Manual page 184

DWS-1008 CLI Reference Guide
rate
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
set radio-profile auto-tune channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios
in a radio profile. At the end of each interval, MSS processes the results of the RF scans
performed during the previous interval, and changes radio channels if needed.
Syntax:
name
seconds
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
D-Link Systems, Inc.
Minimum number of seconds a radio must remain on its current channel
setting before RF Auto-Tuning is allowed to change the channel. You can
specify from 0 to 65535 seconds.
The default RF Auto-Tuning channel holddown is 900 seconds.
Enabled.
The channel holddown applies even if RF anomalies occur that normally
cause an immediate channel change.
The following command changes the channel holddown for radios in radio
profile rp2 to 600 seconds:
set radio-profile name auto-tune channel-interval seconds
Radio profile name.
Number of seconds RF Auto-Tuning waits before changing radio channels to
adjust to RF changes, if needed. You can specify from 0 to 65535 seconds.
The default channel interval is 3600 seconds (one hour).
Enabled.
D-Link recommends that you use an interval of at least 300 seconds (5
minutes). RF Auto-Tuning can change a radio's channel before the channel
interval expires in response to RF anomalies. Even in this case, channel
changes cannot occur more frequently than the channel holddown interval.
If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel
at regular intervals. However, RF Auto-Tuning can still change the channel in
response to RF anomalies.
The following command sets the channel interval for radios in radio profile
rp2 to 2700 seconds (45 minutes):
Access Point Commands
183