Set Igmp Querier; Set Igmp Receiver - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

set igmp querier

Enables or disables the IGMP pseudo-querier on a switch, on one VLAN or all VLANs.
Syntax: set igmp querier {enable | disable} [vlan vlan-id]
enable
disable
vlan vlan-id VLAN name or number. If you do not specify a
Defaults: The pseudo-querier is disabled on all VLANs by default.
Access: Enabled.
Usage: D-Link recommends that you use the pseudo-querier only when
the VLAN contains local multicast traffic sources and no multicast router is
servicing the subnet.
Examples: The following example enables the pseudo-querier on the orange VLAN:
DWS-1008# set igmp querier enable vlan orange
success: change accepted.

set igmp receiver

Adds or removes a network port in the list of ports on which a switch forwards traffic to
multicast receivers. Static multicast receiver ports are immediately added to or removed from
the list of receiver ports and do not age out.
Syntax: set igmp receiver port port-list {enable | disable}
port port-list Network port list. MSS adds the specified ports to
enable
disable
Defaults: By default, no ports are static multicast receiver ports.
D-Link Systems, Inc.
Enables the pseudo-querier.
Disables the pseudo-querier.
VLAN, the pseudo-querier is enabled or disabled
on all VLANs.
the list of static multicast receiver ports.
Adds the port to the list of static multicast receiver
ports.
Removes the port from the list of static multicast
receiver ports.
IGMP Snooping Commands
258