D-Link DWS-1008 Cli Reference Manual page 384

DWS-1008 CLI Reference Guide
Syntax: set log trace mbytes count
count
Defaults: The default trace buffer size is 1 MB.
Access: Enabled.
Examples: The following command increases the trace buffer size to 4 MB:
DWS-1008# set log trace mbytes 4
success: change accepted.
show log buffer
Displays system information stored in the nonvolatile log buffer or the trace buffer.
Syntax: show log buffer [{+|-}number-of-messages] [facility facility-name] [matching
string] [severity severity-level]
buffer
+|-number-of-
messages
facility facility-name Area of MSS that is sending the log
matching string
D-Link Systems, Inc.
Size of the trace buffer, in megabytes (MB). You
can specify from 1 through 50.
Displays the log messages in nonvolatile
storage.
Displays the number of messages specified
as follows:
• A positive number (for example, +100),
displays that number of log entries
starting from the oldest in the log.
• A negative number (for example, -100)
displays that number of log entries
starting from newest in the log.
message. Type a space and a question mark
(?) after show log buffer facility for a list of
valid facilities.
Displays messages that match a string - for
example, a username or IP address.
System Log Commands
383