Set Spantree Uplinkfast; Show Spantree - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
vlan vlan-id VLAN name or number. MSS changes the bridge
Defaults: The default root bridge priority for the switch on all VLANs is 32,768.
Access: Enabled.
Examples: The following command sets the bridge priority of VLAN pink to 69:
DWS-1008# set spantree priority 69 vlan pink
success: change accepted.

set spantree uplinkfast

Enables or disables STP uplink fast convergence on a switch. This feature enables a switch
with redundant links to the network backbone to immediately switch to the backup link to the
root bridge if the primary link fails.
Syntax: set spantree uplinkfast
enable
disable
Defaults: Disabled.
Access: Enabled.
Usage: The uplink fast convergence feature is applicable to bridges that are acting as
access switches to the network core (distribution layer) but are not in the core
themselves. Do not enable the feature on switches that are in the network
core.
Examples: The following command enables uplink fast convergence:
DWS-1008# set spantree uplinkfast enable
success: change accepted.

show spantree

Displays STP configuration and port-state information.
Syntax:
port-list
D-Link Systems, Inc.
priority on only the specified VLAN.
Enables uplink fast convergence.
Disables uplink fast convergence.
show spantree port-list
[
List of ports. If you do not specify any ports, MSS
displays STP information for all ports.
enable | disable}
{
vlan vlan-id active
| ] [
STP Commands
]
239