D-Link DWS-1008 Cli Reference Manual page 200

DWS-1008 CLI Reference Guide
set service-profile psk-phrase
Configures a passphrase for preshared key (PSK) authentication to use for authenticating
WPA clients, in a service profile. Radios use the PSK as a pairwise master key (PMK) to
derive unique pairwise session keys for individual WPA clients.
Syntax:
name
passphrase An ASCII string up to 63 characters long. The string can contain blanks if you
Defaults:
Access:
Usage:
Examples:
DWS-1008# set service-profile sp3 psk-phrase "1234567890123<>?=+&% The quick
brown fox jumps over the lazy sl"
success: change accepted.
set service-profile psk-raw
Configures a raw hexadecimal preshared key (PSK) to use for authenticating WPA clients,
in a service profile. Radios use the PSK as a pairwise master key (PMK) to derive unique
pairwise session keys for individual WPA clients.
Syntax:
name
hex
Defaults:
Access:
Usage:
D-Link Systems, Inc.
set service-profile name psk-phrase passphrase
Service profile name.
use quotation marks at the beginning and end of the string.
None
Enabled
MSS converts the passphrase into a 256-bit binary number for system use
and a raw hexadecimal key to store in the switch's configuration. Neither the
binary number nor the passphrase itself is ever displayed in the configuration.
To use PSK authentication, you must enable it and you also must enable the
WPA IE.
The following command configures service profile sp3 to use passphrase
"1234567890123<>?=+&% The quick brown fox jumps over the lazy sl":
set service-profile name psk-raw hex
Service profile name.
A 64-bit ASCII string representing a 32-digit hexadecimal number. Enter the
two-character ASCII form of each hexadecimal number.
None
Enabled
MSS converts the hexadecimal number into a 256-bit binary number for
system use. MSS also stores the hexadecimal key in the switch's
Access Point Commands
199