Trace Commands - D-Link DWS-1008 Cli Reference Manual
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Cli reference manual (531 pages) ,
- Product manual (502 pages) ,
- User manual (454 pages)
Table of Contents
Advertisement
DWS-1008 CLI Reference Guide
Use trace commands to perform diagnostic routines. While MSS allows you to run many
types of traces, this chapter describes commands for those traces you are most likely to use.
For a complete listing of the types of traces MSS allows, type the set trace ? command.
clear log trace
Deletes the log messages stored in the trace buffer.
Syntax: clear log trace
Defaults: None.
Access: Enabled.
Examples: To delete the trace log, type the following command:
DWS-1008# clear log trace
clear trace
Deletes running trace commands and ends trace processes.
Syntax: clear trace {trace-area | all}
trace-area Ends a particular trace process. Specify one of the
all
Defaults: None.
Access: Enabled.
Examples: To clear all trace processes, type the following command:
DWS-1008# clear trace all
success: clear trace all
D-Link Systems, Inc.
Trace Commands
following keywords to end the traces documented in
this chapter:
• authorization - Ends an authorization trace
• dot1x - Ends an 802.1X trace
• authentication - Ends an authentication trace
• sm - Ends a session manager trace
Ends all trace processes.
Trace Commands
368
Advertisement
Table of Contents
