D-Link DWS-1008 Cli Reference Manual page 72

DWS-1008 CLI Reference Guide
set ip ssh
Changes the TCP port number on which a DWS-1008 switch listens for Secure Shell (SSH)
management traffic.
Caution: If you change the SSH port number from an SSH session, MSS immediately ends
the session. To open a new management session, you must configure the SSH client to use
the new TCP port number.
Syntax: set ip ssh port port-num
port-num TCP port number.
Defaults: The default SSH port number is 22.
Access: Enabled
Examples: The following command changes the SSH port number on a DWS-1008 switch
DWS-1008# set ip ssh port 6000
success: change accepted.
D-Link Systems, Inc.
to 6000:
IP Services Commands
71