D-Link DWS-1008 Cli Reference Manual page 181

DWS-1008 CLI Reference Guide
Usage: This parameter applies to all Distributed APs managed by the switch. If you change
the setting to required, the switch requires Distributed APs to have encryption
keys. The switch also requires their fingerprints to be confirmed in MSS. When
DWL-8220AP security is required, an AP can establish a management session with the
DWS-1008 switch only if its fingerprint has been confirmed by you in MSS.
A change to DWL-8220AP security support does not affect management sessions that are
already established. To apply the new setting to an DWL-8220AP, restart the DWL-8220AP.
Examples:
DWS-1008# set dap security require
set {ap | dap} upgrade-firmware
Disables or reenables automatic upgrade of a DWL-8220AP access point's boot firmware.
Syntax:
ap port-list
dap dap-num
Defaults:
Access:
Usage:
Examples:
DWS-1008# set ap 2 upgrade-firmware disable
set radio-profile 11g-only
Configures each 802.11b/g radio in a radio profile to allow associations with 802.11g
clients only.
Syntax:
name
D-Link Systems, Inc.
The following command configures a DWS-1008 to require Distributed
APs to have encryption keys:
set {ap port-list | dap {dap-num | auto}} upgrade-firmware {enable | disable}
List of ports connected to the DWL-8220AP access point(s) on which
to allow automatic firmware upgrades.
Number of a Distributed AP on which to allow automatic firmware
upgrades.
Automatic firmware upgrades of DWL-8220AP access points are enabled by
default.
Enabled
When the feature is enabled on a DWS-1008 port, a DWL-8220AP access
point connected to that port upgrades its boot firmware to the latest version
stored on the switch while booting.
The following command disables automatic firmware upgrades on the
DWL-8220AP access point connected to port 2:
set radio-profile name 11g-only {enable | disable}
Radio profile name.
Access Point Commands
180