D-Link DWS-1008 Cli Reference Manual page 390

DWS-1008 CLI Reference Guide
Syntax: boot [BT=type] [DEV=device] [FN=filename] [HA=ip-addr] [FL=num]
[OPT=option] [OPT+=option]
BT=type
DEV=device
FN=filename
HA=ip-addr
FL=num
OPT=option
OPT+=option
Defaults: The boot settings in the currently active boot profile are used by default.
Access: Boot prompt.
Usage: If you use an optional parameter, the parameter setting overrides the setting of
the same parameter in the currently active boot profile. However, the boot profile
itself is not changed. To display the currently active boot profile, use the show
command. To change the currently active boot profile, use the change command.
D-Link Systems, Inc.
Boot type:
• c - Compact flash. Boots using nonvolatile storage or a flash card.
• n - Network. Boots using a TFTP server.
Location of the system image file:
• c: - Nonvolatile storage area containing boot partition 0
• d: - Nonvolatile storage area containing boot partition 1
• e: - Primary partition of the flash card in the flash card slot
• f: - Secondary partition of the flash card in the flash card slot
• boot0 - boot partition 0
• boot1 - boot partition 1
System image filename.
Host address (IP address) of a TFTP server. This parameter applies
only when the boot type is n (network).
Number representing the bit settings of boot flags to pass to the
booted system image. Use this parameter only if advised to do so by
D-Link.
String up to 128 bytes of boot options to pass to the booted system
image instead of the boot option(s) in the currently active boot profile.
The options temporarily replace the options in the boot profile. Use
this parameter only if advised to do so by D-Link.
String up to 128 bytes of boot options to pass to the booted system
image in addition to the boot option(s) in the currently active boot
profile. The options are appended to the options already in the boot
profile. Use this parameter only if advised to do so by D-Link.
Boot Prompt Commands
389