D-Link DWS-1008 Cli Reference Manual page 182

DWS-1008 CLI Reference Guide
enable
disable
Defaults:
Access:
Usage:
Examples:
DWS-1008# set radio-profile rp1 11g-only enable
success: change accepted.
set radio-profile active-scan
Disables or reenables active RF detection scanning on the DWL-8220AP radios managed
by a radio profile. When active scanning is enabled, DWL-8220AP radios look for rogue
devices by sending probe any requests (probe requests with a null SSID name), to solicit
probe responses from other access points.
Passive scanning is always enabled and cannot be disabled. During passive scanning,
radios look for rogues by listening for beacons and probe responses.
Syntax:
name
enable
disable
Defaults:
Access:
D-Link Systems, Inc.
Configures radios to allow associations with 802.11g clients only.
Configures radios to allow associations with 802.11g clients and 802.11b
clients.
The default setting is disable.
Enabled
You must disable all radios that are using a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
Even when association of 802.11b clients is disabled, if an 802.11b/g radio
detects a beacon from an 802.11b network, the radio enters protection mode
to guard against interference.
The set radio-profile 11g-only command does not affect the radio support
configured with the set port type ap command. For example, if you configure
a radio to be 802.11b only when you set the port type, the set radio-profile
11g-only enable command does not enable 802.11g support on the radio.
The following command configures the 802.11b/g radios in radio profile rp1 to
allow associations from 802.11g clients only:
set radio-profile name active-scan {enable | disable}
Radio profile name.
Configures radios to actively scan for rogues.
Configures radios to scan only passively for rogues by listening for beacons
and probe responses.
Active scanning is enabled by default.
Enabled.
Access Point Commands
181