D-Link DWS-1008 Cli Reference Manual page 250

DWS-1008 CLI Reference Guide
topology change timer
topology change timer value
hold timer
hold timer value
delay root port timer
delay root port timer value
delay root port timer restarted
is
spanning tree type
spanning tree multicast
address
bridge priority
bridge MAC address
bridge hello time
bridge forward delay
topology change initiator
last topology change occurred System time when the most recent
topology change
D-Link Systems, Inc.
Status of the topology change timer. This
timer determines the time period during
which configured BPDUs are transmitted
with the topology change flag set by this
switch when it is the root bridge, after
detection of a topology change.
Current value of the topology change
timer, in seconds.
Status of the hold timer. This timer
ensures that configured BPDUs are not
transmitted too frequently through any
bridge port.
Current value of the hold timer, in
seconds.
Status of the delay root port timer, which
enables fast convergence when uplink
fast convergence is enabled.
Current value of the delay root port timer.
Whether the delay root port timer has
been restarted.
Type of spanning tree. The type is always
IEEE.
Destination address used to send out
configured BPDUs on a bridge port.
STP priority of this switch.
MAC address of this switch.
Value of the hello timer interval, in
seconds, when this switch is the root or is
attempting to become the root.
Value of the forwarding delay interval, in
seconds, when this switch is the root or is
attempting to become the root.
Port number that initiated the most recent
topology change.
topology change occurred.
Value of the topology change flag in
configuration BPDUs to be transmitted by
this switch on VLANs for which the switch
is the designated bridge.
STP Commands
249