D-Link DWS-1008 Cli Reference Manual page 215

DWS-1008 CLI Reference Guide
show {ap | dap} status
Displays DWL-8220AP access point and radio status information.
Syntax:
Syntax: show dap status [terse] | [dap-num | all [radio {1 | 2}]]
terse
port-list
dap-num
all
radio 1
radio 2
Defaults:
Access:
Note: This field applies to the display for Distributed APs only.
Examples: The following command displays the status of a Distributed AP access point:
DWS-1008# show dap status 1
Dap: 1, IP-addr: 10.2.30.5 (vlan 'vlan-corp'), AP model: DWL-8220AP, manufacturer: D-
Link, name: AP01 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x29c15335347f1919 ram=33554432 s/n=0333703027 hw_rev=A3
Uptime:
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b
protect) operational channel: 1 operational power: 14 base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public bssid2: 00:0b:0e:00:d2:c2, ssid: employee-
net bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled] operational
channel: 64 operational power: 14 base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public bssid2: 00:0b:0e:00:d2:c3,
ssid: employee-net bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
D-Link Systems, Inc.
show ap status [terse] | [port-list | all [radio {1 | 2}]]
Displays a brief line of essential status information for each DWL-8220AP.
List of ports connected to the DWL-8220AP access point(s) for which to
display status.
Number of a Distributed AP for which to display status.
Shows status information for all directly attached DWL-8220AP access points
and all Distributed AP access points configured on the switch.
Shows status information for radio 1.
Shows status information for radio 2. (This option does not apply to
single-radio models.)
None.
Enabled.
18 hours, 36 minutes, 27 seconds
Access Point Commands
214