Fujitsu MB91260B Series Hardware Manual page 359

CHAPTER 14 8/10-BIT A/D CONVERTER
References:
The example of conversion order in continuous conversion mode is shown in following.
• When ANS=000
that order.
• When ANS=110
in that order.
• When ANS=011
Notes:
• A/D unit 1 uses the 2 channels AN8 and AN9, and A/D unit 2 uses the 2 channels AN10 and
AN11.
• Always write "0" to ANE1, ANE2, ANS2, and ANS1 of A/D units 1 and 2.
• Be sure to set A/D units 1 and 2 so that ANS0 is less than or equal to ANE0.
344
and ANE=011 , conversion iterates over AN0, AN1, AN2, AN3, and AN0, in
B B
and ANE=010 , conversion iterates over AN6, AN7, AN0, AN1, AN2 and AN6,
B B
and ANE=011 , conversion iterates over AN3 and AN3, in that order.
B B