Table of Contents
Advertisement
Table 11.4-4 Compare Control Register, Upper Byte (OCSH1, OCSH3, OCSH5) (2 / 2)
Bit Name
OTE1:
bit11
Output enable bit
OTE0:
bit10
Output enable bit
OTD1:
bit9
Output level bit
OTD0:
bit8
Output level bit
• This bit is used to enable the waveform generator output (RTO1, RTO3, RTO5) to ports.
• The initial value of this bit is "0".
Note:
When the waveform generator is disabled (the lower of the 16-bit dead timer control register
(DTCR0, DTCR1, DTCR2), TMD2 to TMD0,TMD5 to TMD3, TMD8 to TMD6: bit2 to bit0 =
000
), RTO1, RTO3, RTO5 outputs the same value as the output compare.
B
• This bit is used to enable the waveform generator output (RTO0, RTO2, RTO4) to ports.
• The initial value of this bit is "0".
Note:
When the waveform generator is disabled (the lower of the 16-bit dead timer control register
(DTCR0, DTCR1, DTCR2), TMD2 to TMD0,TMD5 to TMD3, TMD8 to TMD6: bit2 to bit0 =
000
), RTO0, RTO2, RTO4 outputs the same value as the output compare.
B
• This bit is used to change a pin output level of the output compare 1, 3, 5 (RT1, RT3, RT5).
• The initial value of the compare pin output is "0".
• Before data is written, be sure to stop the compare operation. The read value of this bit
indicates the output compare value of RT1, RT3, RT5.
• This bit is used to change a pin output level of the output compare 0, 2, 4 (RT0, RT2, RT4).
• The initial value of the compare pin output is "0".
• Before data is written, be sure to stop the compare operation. The read value of this bit
indicates the output compare value of RT0, RT2, RT4.
CHAPTER 11 MULTIFUNCTIONAL TIMER
Function
231
Advertisement
Table of Contents
