Verifying Autoinstallation On Acx Series Universal Access Routers - Juniper ACX1000 Configuration Manual

Related
Documentation

Verifying Autoinstallation on ACX Series Universal Access Routers

Purpose
Action
Sample Output
Copyright © 2017, Juniper Networks, Inc.
user@host# set autoinstallation configuration-servers tftp://tftpconfig.sp.com
NOTE: You can also use an HTTP or FTP address—for example,
http://user:password@httpconfig.sp.com
ftp://user:password@sftpconfig.sp.com
Configure one or more Ethernet interfaces to perform autoinstallation and IP address
2.
acquisition protocols for each interface. The router uses the protocols to send a request
for an IP address for the interface:
[edit system]
user@host# set autoinstallation interfaces ge-0/0/0 bootp
ACX Series Autoinstallation Overview on page 75
Before You Begin Autoinstallation on an ACX Series Universal Access Router on page 77
Verifying Autoinstallation on ACX Series Universal Access Routers on page 79
USB Autoinstallation on ACX Series Routers on page 80
autoinstallation on page 1442
show system autoinstallation status on page 3178
After you have configured autoinstallation, display the status of autoinstallation on an
ACX Series router.
From the CLI, enter the show system autoinstallation status
user@host> show system autoinstallation status
Autoinstallation status:
Master state: Active
Last committed file: None
Configuration server of last committed file: 10.25.100.1
Interface:
Name: ge-0/1/0
State: Configuration Acquisition
Acquired:
Address: 192.168.124.75
Hostname: host-ge-000
Hostname source: DNS
Configuration filename: router-ge-000.conf
Configuration filename server: 10.25.100.3
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Chapter 3: Configuring Autoinstallation
or
.
command.
79