Juniper ACX1000 Configuration Manual page 154

ACX Series Universal Access Router Configuration Guide
Related
Documentation
96
Media type specification (ACX1000 router with Gigabit Ethernet SFP and RJ45
interfaces)
Autonegotiation for RJ45 Gigabit Ethernet interfaces
Event handling of SFP insertion and removal
Explicit disabling of the physical interface
Flow control
NOTE: The ACX Series router does not support flow control based on
PAUSE frames.
Loopback
Loss of signal (LOS) alarm
Media access control (MAC) layer features
Maximum transmission unit (MTU)
Remote fault notification for 10-Gigabit Ethernet interfaces
Statistics collection and handling
Power over Ethernet (PoE) (ACX2000 router)
High power mode
The Gigabit Ethernet ports on the router have the capacity to work as a 1 or 10-Gigabit
Ethernet interface, depending on the type of small form-factor pluggable (SFP)
transceiver inserted. When you insert an SFP+ transceiver, the interface works at the
10-Gigabit speed. When you insert an SFP transceiver, the interface works at the 1-Gigabit
speed. Configuration is not required because the speed is determined automatically
based on the type of inserted SFP transceiver. The dual-speed interface is automatically
created with the prefix, for example,
xe
The same configuration statements are used for both speeds and CoS parameters are
scaled as a percentage of the port speed. To configure a dual-speed Gigabit Ethernet
interface, include the
interface xe-fpc/pic/port
level. To display the interface speed and other details, issue the
NOTE: You need to use industrial grade of SFP below 0dC for ACX 1100 and
ACX 2100 boards.
Understanding Encapsulation on an Interface on page 104
Configuring Inverse Multiplexing for ATM (IMA) on page 185
Interface Names for ACX Series Universal Access Routers
.
xe-4/0/0
statement at the [
edit interfaces
show interfaces
Copyright © 2017, Juniper Networks, Inc.
] hierarchy
command.