Configuring One Full T1 Or E1 Interface On Channelized T1 And E1 Interfaces - Juniper ACX1000 Configuration Manual

Configuring One Full T1 or E1 Interface on Channelized T1 and E1 Interfaces

Copyright © 2017, Juniper Networks, Inc.
NOTE: If you set the
operation fails.
If you change the mode, the router will reboot the built-in T1 and E1 interfaces.
Bit error rate test (BERT) patterns with all ones received by T1 and E1
interfaces configured for SAToP do not result in an alarm indication signal
(AIS) defect. As a result, the T1 and E1 interfaces remain up.
You must configure a child T1 or E1 interface on the built-in channelized T1 or E1 interface
created because the channelized interface is not a configurable interface and SAToP
encapsulation must be configured (in the next step) for the pseudowire to function. The
following configuration creates one full T1 interface on the channelized
can follow the same process to create one E1 interface on the channelized
Configure one full T1/E1 interface:
[edit interfaces ct1-fpc/pic /port]
user@host# set no-partition interface-type (t1 | e1)
For example:
[edit interfaces ct1-0/0/0
user@host# set no-partition interface-type t1
The following output shows this configuration:
[edit]
user@host# show interfaces
ct1-0/0/0 {
no-partition interface-type t1;
}
The preceding command creates the
interface. Check the configuration with the
command. Run the command to display output for the channelized interface and the
newly created T1 or E1interface. The following output provides an example of the output
for a CT1 interface and the T1 interface created from the preceding example configuration.
Notice that is running at T1 speed and that the media is T1.
ct1-0/0/0
user@host> show interfaces ct1-0/0/0 extensive
Physical interface: ct1-0/0/0, Enabled, Physical link is Up
Interface index: 152, SNMP ifIndex: 780, Generation: 1294
Link-level type: Controller, Clocking: Internal, Speed: T1, Loopback: None,
Framing: ESF, Parent: None
Device flags : Present Running
Interface flags: Point-To-Point SNMP-Traps Internal: 0x0
Link flags : None
Hold-times : Up 0 ms, Down 0 ms
CoS queues : 8 supported, 4 maximum usable queues
Last flapped : 2012-04-03 06:27:55 PDT (00:13:32 ago)
Chapter 7: Configuring SAToP Support on Interfaces
option incorrectly for the PIC type, the commit
framing
interface on the channelized
t1-0/0/0
show interfaces interface-name extensive
ct1 interface. You
interface.
ce1
ct1-0/0/0
193