Bert Support On Ct1 And Ce1 Interfaces - Juniper ACX1000 Configuration Manual

Related
Documentation

BERT Support on CT1 and CE1 Interfaces

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
NOTE:
When you configure the Tri-Rate Ethernet copper interface to operate at
1 Gbps, autonegotiation must be enabled.
On ACX Series Universal Access Routers, when the autonegotiation is
disabled, the speed has to be explicitly configured to 10–100 Mbps.
On T4000 routers, the
other than Gigabit Ethernet.
Configuring Gigabit Ethernet Autonegotiation
Ethernet Interfaces Feature Guide for Routing Devices
For ACX Series routers, BERT is supported on
algorithms are supported:
all-ones-repeating
all-zeros-repeating
alternating-double-ones-zeros
alternating-ones-zeros
repeating-1-in-4
repeating-1-in-8
repeating-3-in-24
pseudo-2e11-o152
pseudo-2e15-o151
pseudo-2e20-o151
NOTE: User-defined BERT patterns are not supported.
Configuring E1 BERT Properties on page 165
Configuring T1 BERT Properties on page 168
Chapter 4: Configuring Interfaces and Chassis
command is ignored for interfaces
auto-negotiation
and interfaces. The following BERT
ct1 ce1
105