Juniper ACX1000 Configuration Manual page 203

Requirements
Overview
Table 22: Components of the PoE Configuration
Property
Hardware
VLAN name
Connection to a wireless access point (requires PoE)
Power port priority
Maximum power available to PoE port
PoE management mode
Direct connections to desktop PCs, file servers, integrated
printer/fax/copier machines (no PoE required)
Unused ports (for future expansion)
Copyright © 2017, Juniper Networks, Inc.
Configuration on page 146
Verification on page 147
This example uses the following software and hardware components:
Junos OS Release 12.2 or later for ACX Series routers
An ACX2000 router that supports PoE
Before you configure PoE, be sure you have:
Performed the initial router configuration. See
on page 75,"Verifying Autoinstallation on ACX Series Universal Access Routers" on
page 79, and "Boot Sequence on ACX Series Routers" on page 48
This example consists of a router that has eight ports. Only two ports—ge-0/1/3 and
ge-0/1/7—support PoE, which means they provide both network connectivity and electric
power for powered devices such as VoIP telephones, wireless access points, and IP
security cameras that require power up to 65 W. The remaining six ports provide only
network connectivity. You use the standard ports to connect devices that have their own
power sources, such as desktop and laptop computers, printers, and servers.
Table 22 on page 145 details the topology used in this configuration example.
Chapter 4: Configuring Interfaces and Chassis
"ACX Series Autoinstallation Overview"
Settings
ACX2000 router with 8 Gigabit Ethernet ports: Two PoE
interfaces (ge-0/1/3 and ge-0/1/7) and 6 non-PoE interfaces
(ge-0/1/0, ge-0/1/1, ge-0/1/2, ge-0/1/4, ge-0/1/5, ge-0/1/6).
default
ge-0/1/7
high
65 W
high-power
ge-0/1/0 through ge-0/1/2
ge-0/1/4 through ge-0/1/6
for details.
145