Configuring Cesopsn Support On Interfaces; Configuring Cesopsn Encapsulation On Ds Interfaces - Juniper ACX1000 Configuration Manual

CHAPTER 8
Configuring CESoPSN Support on
Interfaces

Configuring CESoPSN Encapsulation on DS Interfaces

Copyright © 2017, Juniper Networks, Inc.
Configuring CESoPSN Encapsulation on DS Interfaces on page 205
Configuring CESoPSN on Channelized OC3/STM1 (Multi-Rate) Circuit Emulation MIC
with SFP on page 206
Configuring CESoPSN Encapsulation on DS Interfaces on page 215
Configuring CE1 Channels Down to DS Interfaces on page 218
Configuring CESoPSN on Channelized E1/T1 Circuit Emulation MIC on page 220
Circuit Emulation Service over Packet-Switched Network (CESoPSN) is an encapsulation
layer intended to carry NxDS0 services over a packet-switched network (PSN).
To configure CESoPSN encapsulation on a DS interface:
Create the DS interface.
1.
[edit interfaces]
user@host# edit interface ds-fpc/pic/port:partition
For example:
[edit interfaces]
user@host# edit interface ds-0/0/1:1
Configure the encapsulation.
2.
[edit interfaces ds-fpc/pic/port:partition]
user@host# set encapsulation cesopsn
Configure the logical interface.
3.
[edit interfaces ds-fpc/pic/port:partition]
user@host# set unit logical-unit-number
For example:
[edit interfaces ds-0/0/1:1]
user@host# set unit 0
205