Configuring The Pseudowire Interface - Juniper ACX1000 Configuration Manual

Configuring the Pseudowire Interface

Copyright © 2017, Juniper Networks, Inc.
—Number of packets in the jitter buffer (from 1 through 64
jitter-buffer-packets
packets).
packetization-latency
microseconds).
—Payload size for virtual circuits that terminate on Layer 2 interworking
payload-size
(iw) logical interfaces (from 32 through 1024 bytes).
NOTE: This topic shows the configuration of only one CESoPSN option.
You can follow the same method to configure all the other CESoPSN
options.
[edit interfaces ds-fpc-slot/pic-slot/port:channel cesopsn-options]
user@host# set excessive-packet-loss-rate sample-period sample-period
For example:
[edit interfaces ds-1/0/0:1:1:1 cesopsn-options]
user@host# set excessive-packet-loss-rate sample-period 4000
To verify the configuration using the values shown in the examples, use the
command at the
[edit interfaces ds-1/0/0:1:1:1]
[edit interfaces ds-1/0/0:1:1:1]
user@host# show
cesopsn-options {
excessive-packet-loss-rate {
sample-period 4000;
}
}
To configure the TDM pseudowire at the provider edge (PE) router, use the existing
Layer 2 circuit infrastructure, as shown in the following procedure:
In configuration mode, go to the
1.
[edit]
user@host# edit protocol l2circuit
Configure the IP address of the neighboring router or switch, the interface forming the
2.
Layer 2 circuit, and the identifier for the Layer 2 circuit.
[edit protocol l2circuit]
user@host# set neighbor ip-address interface
interface-name-fpc-slot/pic-slot/port.interface-unit-number virtual-circuit-id
virtual-circuit-id
For example:
[edit protocol l2circuit]
user@host# set neighbor 10.255.0.6 interface ds-1/0/0:1:1:1 virtual-circuit-id 1
Chapter 8: Configuring CESoPSN Support on Interfaces
—Time required to create packets (from 1000 through 8000
hierarchy level:
[edit protocols l2circuit]
show
hierarchy level.
217