Configuring Ct1 Ports Down To T1 Channels; Configuring Ct1 Ports Down To Ds Channels - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring CT1 Ports Down to T1 Channels

Configuring CT1 Ports Down to DS Channels

202
Bit error rate test (BERT) patterns with all binary 1s (ones) received by CT1/CE1 interfaces
on Circuit Emulation MICs configured for SAToP do not result in an alarm indication signal
(AIS) defect. As a result, the CT1/CE1 interfaces remain up.
To configure a CT1 port down to a T1 channel, use the following procedure:
NOTE: To configure a CE1 port down to the E1 channel, replace ct1 with ce1
and t1 with e1 in the procedure.
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces ct1-mpc-slot/mic-slot/port-number
For example:
[edit]
user@host# edit interfaces ct1-1/0/0
On the CT1 interface, set the
2.
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
user@host# set no-partition interface-type t1
In the following example, the ct1-1/0/1 interface is configured to be of type T1 and to
have no partitions.
[edit interfaces ct1-1/0/1]
user@host# set no-partition interface-type t1
To configure a channelized T1 (CT1) port down to a DS channel, include the
statement at the
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
NOTE: To configure a CE1 port down to a DS channel, replace ct1 with ce1 in
the following procedure.
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces ct1-mpc-slot/mic-slot/port-number
For example:
[edit]
user@host# edit interfaces ct1-1/0/0
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
option and then set the interface type as T1.
no-partition
[edit interfaces ct1-mpc-slot/mic-slot/port-number]
Copyright © 2017, Juniper Networks, Inc.
partition
hierarchy level: