Configuring Cesopsn Encapsulation On Ds Interfaces On Ce1 Channels; Configuring Cstm1 Ports Down To Ce1 Channels - Juniper ACX1000 Configuration Manual

Configuring CESoPSN Encapsulation on DS Interfaces on CE1 Channels

Copyright © 2017, Juniper Networks, Inc.
user@host# show
encapsulation cesopsn;
unit 0;
This topic includes the following tasks:
Configuring CSTM1 Ports Down to CE1 Channels on page 211
Configuring CSTM4 Ports Down to CE1 Channels on page 212
Configuring CE1 Channels Down to DS Interfaces on page 213
Configuring CESoPSN on DS Interfaces on page 214

Configuring CSTM1 Ports Down to CE1 Channels

On any port configured for SDH framing (numbered 0 through 3), you can configure one
CAU4 channel. On each CAU4 channel, you can configure 31 CE1 channels (numbered 1
through 31).
To configure CSTM1 channelization down to CAU4 and then down to CE1 channels,
include the partition statement at the
cstm1)-mpc-slot/mic-slot/port-number]
In configuration mode, go to the
1.
hierarchy level.
[edit]
user@host# edit interfaces cstm1-mpc-slot/mic-slot/port-number
For example:
[edit]
user@host# edit interfaces cstm1-1/0/1
On the CSTM1 interface, set the
2.
as .
cau4
[edit interfaces cstm1-mpc-slot/mic-slot/port-number]
user@host# set no-partition interface-type cau4
For example:
[edit interfaces cstm1-1/0/1]
user@host# set no-partition interface-type cau4
Enter the up command to go to the
3.
[edit interfaces cstm1-mpc-slot/mic-slot/port-number]
user@host# up
For example:
[edit interfaces cstm1-1/0/1]
user@host# up
Chapter 8: Configuring CESoPSN Support on Interfaces
[edit interfaces (cau4 |
hierarchy level, as shown in the following example:
[edit interfaces cstm1-mpc-slot/mic-slot/port-number]
option, and then set the interface type
no-partition
[edit interfaces] hierarchy level.
211