Configuring IMA Group Options
Copyright © 2017, Juniper Networks, Inc.
To configure the various options for an IMA group on an ATM interface:
In configuration mode, go to the
1.
hierarchy level, where the interface name is
[edit]
user@host# edit interface interface-name ima-group-options
Configure the maximum differential delay between the links in the IMA group. You
2.
can configure the maximum differential delay from 1 millisecond through 56
milliseconds. By default, 25 milliseconds is set.
[edit interface interface-name ima-atm-options]
user@host# set differential-delay delay
Configure the frame length of the ICP cell as 32, 64, 128, or 256. By default, 128 is set.
3.
[edit interface interface-name ima-atm-options]
user@host# set frame-length length
Configure the IMA group frame synchronization state parameters alpha, beta, and
4.
gamma.
[edit interface interface-name ima-atm-options]
user@host# set alpha number beta number gamma number
For the default values and parameter range for alpha, beta, and gamma, see
"Understanding ATM IMA Configuration on ACX Series Router" on page
Configure IMA group minimum active links. You can configure between 1 to 16 links. 1
5.
is set by default.
[edit interface interface-name ima-atm-options]
user@host# set minimum-links links
Configure the symmetry of the IMA group as either symmetrical configuration and
6.
operation or symmetrical configuration and asymmetrical operation.
[edit interface interface-name ima-atm-options]
user@host# set symmetry (symmetrical-config-and-operation |
symmetrical-config-asymmetrical-operation)
For information about symmetry, see
Series Router" on page
Configure a test procedure to start and end the test pattern procedure.
7.
[edit interface interface-name ima-atm-options]
user@host# set ima-test-start
user@host# ima-test-stop
user@host# interface interface-name
[edit interfaces interface-name ima-group-options]
at-fpc/pic/port
"Understanding ATM IMA Configuration on ACX
174.
Chapter 6: Configuring ATM Interfaces
.
174.
183