Juniper ACX1000 Configuration Manual page 224

ACX Series Universal Access Router Configuration Guide
Related
Documentation
166
is the bit error rate. This can be an integer from 0 through 7, which corresponds to a
rate
–0
bit error rate from 10 (0, which corresponds to no errors) to 10
bits). The default is 0.
NOTE: The bit-error-rate statement in BERT procedure is not supported on
the 16-port Channelized E1/T1 Circuit Emulation MIC (MIC-3D-16CHE1-T1-CE).
Individual concatenated E1 interfaces do not support the
statement. For individual concatenated E1 interfaces, the
the [edit interfaces interface-name e1-options]
for the E1 BERT procedure is
O.151 standard).
For channelized E1 intelligent queuing (IQ and IQE) interfaces, you can configure the
BERT algorithm by including the
ce1-fpc/pic/port e1-options]
[edit interfaces ce1-fpc/pic/port e1-options]
bert-algorithm algorithm;
[edit interfaces e1-fpc/pic/port e1-options]
bert-algorithm algorithm;
For a list of supported algorithms, enter a
example:
[edit interfaces ce1-0/0/0 e1-options]
user@host# set bert-algorithm ?
Possible completions:
pseudo-2e11-o152 Pattern is 2^11 -1 (per O.152 standard)
pseudo-2e15-o151 Pattern is 2^15 - 1 (per O.151 standard)
pseudo-2e20-o151 Pattern is 2^20 - 1 (per O.151 standard)
pseudo-2e20-o153 Pattern is 2^20 - 1 (per O.153 standard)
For specific hierarchy information, see individual interface types. For information about
running the BERT procedure, see the
Configuring T1 BERT Properties on page 168
Configuring Interface Diagnostics Tools to Test the Physical Layer Connections
hierarchy level is ignored. The algorithm
(pattern is 2
pseudo-2e15-o151
statement at the
bert-algorithm
or
[edit interfaces e1-fpc/pic/port e1-options]
after the
? bert-algorithm
.
CLI Explorer
–7
(1 error per 10 million
configuration
bert-algorithm
statement at
bert-algorithm
15
–1, as defined in the CCITT/ITU
[edit interfaces
hierarchy level:
statement; for
Copyright © 2017, Juniper Networks, Inc.