Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation
Understanding In-Service Software Upgrade (ISSU) in ACX5000 Series Routers
68
The root ( ) and
/ /config
active NAND flash slice.
Scenario: To take a snapshot from a USB storage device to the active slice of the NAND
flash device after partitioning:
Boot up the router from a USB storage device containing the required Junos OS image.
1.
Issue the
request system snapshot partition
2.
user@host> request system snapshot partition
Verifying compatibility of destination media partitions...
Running newfs (439MB) on internal media
Running newfs (46MB) on internal media
Copying '/dev/da1s1a' to '/dev/da0s1a' .. (this may take a few minutes)
Copying '/dev/da1s1e' to '/dev/da0s1e' .. (this may take a few minutes)
The following filesystems were archived: / /config
The BSD label (disk partitioning information) for the active flash slice is installed and
then the root ( ) and
/ /config
the active NAND flash slice.
Understanding System Snapshot on an ACX Series Router on page 64
request system snapshot (ACX Series) on page 1807
An in-service software upgrade (ISSU) enables you to upgrade between two different
Junos OS releases with minimal disruption on the control plane and with minimal
disruption of traffic. During an ISSU, the Junos OS runs in two separate virtual machines
(VMs)—one VM is in the master role acting as the master Routing Engine, and the other
VM is in the backup role acting as the backup Routing Engine. The Junos OS is upgraded
on the backup VM. After a successful software upgrade, the backup VM then becomes
the master VM, and the original master VM is no longer needed and is shut down.
NOTE: ISSU is supported in Junos OS Release 15.1X54–D60 or later for
ACX5000 Series routers.
ISSU provides the following benefits:
Eliminates network downtime during software image upgrades
Reduces operating costs, while delivering higher service levels
Allows fast implementation of new features
In-Service Software Upgrade Process on page 69
directories from the USB storage device are copied to the
command.
/ partition (da0s1a)...
/config partition (da0s1e)...
directories from the USB storage device are copied to
Copyright © 2017, Juniper Networks, Inc.