Configuring Cesopsn On Channelized E1/T1 Circuit Emulation Mic; Configuring T1/E1 Framing Mode At The Mic Level - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Configuring CESoPSN on Channelized E1/T1 Circuit Emulation MIC

Configuring T1/E1 Framing Mode at the MIC Level

220
From configuration mode, confirm your configuration by entering the
For example:
[edit interfaces]
user@host# show
ce1-0/0/1 {
partition 1 timeslots 1-4 interface-type ds;
}
ds-0/0/1:1 {
encapsulation cesopsn;
unit 0;
}
Understanding Mobile Backhaul
Configuring CESoPSN Encapsulation on DS Interfaces on page 215
This configuration applies to the mobile backhaul application shown in Mobile Backhaul
Application.
Configuring T1/E1 Framing Mode at the MIC Level on page 220
Configuring CT1 Interface Down to DS channels on page 221
Configuring CESoPSN on DS Interfaces on page 222
To set the framing mode at the MIC (ACX-MIC-16CHE1-T1-CE) level, for all four ports on
the MIC, include the
framing
level.
[edit chassis fpc slot pic slot]
user@host# set framing (t1 | e1);
After a MIC is brought online, interfaces are created for the MIC's available ports on the
basis of the MIC type and the framing option used.
If you include the
framing t1
If you include the framing e1
NOTE: If you set the
operation fails.
Bit error rate test (BERT) patterns with all binary 1s (ones) received by CT1/CE1
interfaces on Circuit Emulation MICs configured for CESoPSN do not result
in an alarm indication signal (AIS) defect. As a result, the CT1/CE1 interfaces
remain up.
statement at the
[edit chassis fpc slot pic slot]
statement, 16 CT1 interfaces are created.
statement, 16 CE1 interfaces are created.
option incorrectly for the MIC type, the commit
framing
command.
show
hierarchy
Copyright © 2017, Juniper Networks, Inc.