Configuring Cesopsn On Ds Interfaces - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
210
NOTE: You can assign multiple time slots on a CT1 interface. In the
command, separate the time slots by commas and do not include spaces
between them. For example:
[edit interfaces ct1-1/0/0:1:1]
user@host# set partition 1 timeslots 1-4,9,22-24 interface-type ds
To verify this configuration, use the
hierarchy level.
[edit interfaces ct1-1/0/0:1:1]
user@host# show
partition 1 timeslots 1-4 interface-type ds;
An NxDS0 interface can be configured from channelized T1 interface (ct1). Here N
represents the time slots on the CT1 interface.
The value of N is 1 through 24 when a DS0 interface is configured from a CT1 interface.
After you partition the DS interface, configure the CESoPSN options on it. See
the CESoPSN Options" on page

Configuring CESoPSN on DS Interfaces

To configure CESoPSN encapsulation on a DS interface, include the
statement at the [edit interfaces
ds-mpc-slot/mic-slot/port-number:channel:channel:channel]
In configuration mode, go to the
1.
ds-mpc-slot/mic-slot/port-number:channel:channel:channel]
[edit]
user@host# edit interfaces ds-mpc-slot/mic-slot/ port-number:channel:channel:channel
For example:
[edit]
user@host# edit interfaces ds-1/0/0:1:1:1
Configure CESoPSN as the encapsulation type and the logical interface for the DS
2.
interface.
[edit interfaces ds-mpc-slot/mic-slot/port-number:channel:channel:channel]
user@host# set encapsulation cesopsn unit interface-unit-number
For example:
[edit interfaces ds-1/0/0:1:1:1 ]
user@host# set encapsulation cesopsn unit 0
To verify this configuration, use the
hierarchy level.
[edit interfaces ds-1/0/0:1:1:1]
command at the
show
216.
[edit interfaces
command at the
show
Copyright © 2017, Juniper Networks, Inc.
set
[edit interfaces ct1-1/0/0:1:1]
"Setting
encapsulation
hierarchy level.
hierarchy level.
[edit interfaces ds-1/0/0:1:1:1]