Usb Autoinstallation On Acx Series Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Meaning
Related
Documentation

USB Autoinstallation on ACX Series Routers

80
Protocol: RARP Client
Acquired address: None
Interface:
Name: ge-0/1/1
State: None
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Protocol: RARP Client
Acquired address: None
The output shows the settings configured for autoinstallation. Verify that the values
displayed are correct for the router when it is deployed on the network.
ACX Series Autoinstallation Overview on page 75
Before You Begin Autoinstallation on an ACX Series Universal Access Router on page 77
Autoinstallation Configuration of ACX Series Universal Access Routers on page 78
USB Autoinstallation on ACX Series Routers on page 80
autoinstallation on page 1442
show system autoinstallation status on page 3178
If you have a new ACX Series router, you can use a Disk-on-Key USB memory stick ("USB
key") to configure the router.
This configuration method has the following requirements:
A management device (PC or laptop).
A Disk-on-Key device with one of the following 16-bit or 32-bit file allocation table
(FAT) file systems:
DOS 3.0+ 16-bit FAT (up to 32 MB)
DOS 3.31+ 16-bit FAT (over 32 MB)
FAT32
FAT32, LBA-mapped
16-bit FAT, LBA-mapped
An ACX Series router with the factory configuration. If other Junos OS configuration
files exist on the router, the router cannot read the
Disk-on-Key device.
juniper-config.txt file from the
Copyright © 2017, Juniper Networks, Inc.