Example: Configuring Poe On Acx2000 Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Table 21: PoE Configuration Options and Default Settings (continued)
Option Default
0 W
guard-band
management static
Interface Options
Not included in default
disable (Power over
configuration
Ethernet)
low
priority (Power over
Ethernet)
telemetries Not included in default
configuration
Related
Documentation

Example: Configuring PoE on ACX2000 Routers

144
Description
Reserves up to 19 W power from the PoE power budget to be used in
the case of a spike in PoE power consumption.
Sets the PoE power management mode for the router. The power
management mode determines how power to a PoE interface is
allocated:
class
static
device connected.
high-power
When included in the configuration, disables PoE on the interface. The
interface maintains network connectivity but no longer supplies power
to a connected powered device. Power is not allocated to the interface.
Sets an interface's power priority to either
insufficient for all PoE interfaces, the PoE power to low-priority interfaces
is shut down before power to high-priority interfaces is shut down. Among
interfaces that have the same assigned priority, the power priority is
determined by port number, with lower-numbered ports having higher
priority.
When included in the configuration, enables the logging of power
consumption records on an interface. Logging occurs every 5 minutes
for 1 hour unless you specify a different value for
Ethernet)
Example: Configuring PoE on ACX2000 Routers on page 144
Example: Disabling a PoE Interface on ACX2000 Routers on page 149
Power over Ethernet (PoE) ports supply electric power over the same ports that are used
to connect network devices. These ports allow you to plug in devices that need both
network connectivity and electric power, such as voice over IP (VoIP) phones, wireless
access points, and IP cameras.
This example shows how to configure PoE to deliver power up to 65 W on ACX2000
interfaces:
Requirements on page 145
Overview on page 145
—Power allocated for each interface can be configured.
—Power allocated for interfaces is based on the class of powered
—Power allocated for interfaces up to 65 W per port.
or duration.
Copyright © 2017, Juniper Networks, Inc.
or . If power is
low high
interval (Power over