Configuring The Pseudowire Interface - Juniper ACX1000 Configuration Manual

Copyright © 2017, Juniper Networks, Inc.
—Time required to calculate excessive packet loss rate (from 1000
sample-period
through 65,535 milliseconds).
threshold —Percentile designating the threshold of excessive packet loss rate
(1–100 percent).
—An 8-bit hexadecimal pattern to replace TDM data in a lost packet
idle-pattern
(from 0 through 255).
jitter-buffer-auto-adjust
NOTE: The
routers.
—Time delay in the jitter buffer (from 1 through 1000
jitter-buffer-latency
milliseconds).
jitter-buffer-packets —Number of packets in the jitter buffer (from 1 through 64
packets).
—Configure the payload size, in bytes (from 32 through 1024 bytes).
payload-size
NOTE: In this section, we are configuring only one SAToP option. You can
follow the same method to configure all the other SAToP options.
[edit interfaces e1-1/0/0 satop-options]
user@host# set excessive-packet-loss-rate sample-period sample-period
For example:
[edit interfaces e1-1/0/0 satop-options]
user@host# set excessive-packet-loss-rate sample-period 4000
To verify this configuration, use the
hierarchy level:
[edit interfaces e1-1/0/0]
user@host# show
satop-options {
excessive-packet-loss-rate {
sample-period 4000;
}
}

Configuring the Pseudowire Interface

To configure the TDM pseudowire at the provider edge (PE) router, use the existing
Layer 2 circuit infrastructure, as shown in the following procedure:
In the configuration mode, go to
1.
[edit]
user@host# edit protocol l2circuit
Chapter 7: Configuring SAToP Support on Interfaces
—Automatically adjust the jitter buffer.
option is not applicable on MX Series
jitter-buffer-auto-adjust
command at the
show
[edit protocols l2circuit]
[edit interfaces e1-1/0/0]
hierarchy level.
199