Mld Multicast Vlan Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
MLD M
ULTICAST
Back to Section Header
The MLD Multicast VLAN commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
C
OMMAND
create mld_snooping
multicast_vlan
config mld_snooping
multicast_vlan
create mld_snooping
multicast_vlan_group_profile
config mld_snooping
multicast_vlan_group_profile
delete mld_snooping
multicast_vlan_group_profile
show mld_snooping
multicast_vlan_group_profile
config mld_snooping
multicast_vlan_group
show mld_snooping
multicast_vlan_group
delete mld_snooping multicat_vlan
enable mld_snooping
multicast_vlan
disable mld_snooping
multicast_vlan
show mld_snooping multicast_vlan
config mld_snooping
multicast_vlan forward_unmatched
Each command is listed, in detail, in the following sections.
create mld_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
VLAN C
P
ARAMETERS
<vlan_name 32> <vlanid 2-4094> {remap_priority [<value 0-7> |
none] { replace_priority}}
<vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>]
|tag_member_port <portlist>]| state [enable | disable]
|replace_source_ip <ipv6addr>| remap_priority [<value 0-7> |
none] { replace_priority}}(1)
<profile_name 1-32>
<profile_name 1-32> [add | delete] <mcastv6_address_list>
[profile_name <profile_name 1-32> |all]
{<profile_name 1-32>}
<vlan_name 32> [add | delete] profile_name <profile_name 1-32>
{< vlan_name 32> }
<vlan_name 32>
{<vlan_name 32>}
[disable | enable]
Used to create an MLD multicast VLAN
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>
{remap_priority [<value 0-7> | none] { replace_priority}}
This command is used to create a MLD multicast_vlan. Multiple multicast VLANs
can be configured.
The MLD multicast VLAN being created can not exist in the 1Q VLAN database.
Multiple MLD multicast VLANs can be created. The MLD Multicast VLAN
snooping function co-exists with the 1Q VLAN snooping function.
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given
a name that can be up to 32 characters.
OMMANDS
Page | 235