Dhcp Relay Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DHCP R
ELAY
Back to Section Header
The DHCP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
config dhcp_relay
config dhcp_relay add ipif
config dhcp_relay delete ipif
config dhcp_relay option_60 add
config dhcp_relay option_60 delete
show dhcp_relay option_60
config dhcp_relay option_60
default
config dhcp_relay option_60 state
config dhcp_relay option_61 add
show dhcp_relay option_61
config dhcp_relay option_61 delete
config dhcp_relay option_61
default
config dhcp_relay option_61 state
config dhcp_relay option_82 state
config dhcp_relay option_82 check
config dhcp_relay option_82
remote_id
config dhcp_relay option_82 policy
show dhcp_relay
enable dhcp_relay
disable dhcp_relay
config dhcpv6_relay hop_count
config dhcpv6_relay
config dhcpv6_relay ipif
show dhcpv6_relay
enable dhcpv6_relay
disable dhcpv6_relay
Each command is listed in detail in the following sections.
config dhcp_relay
Purpose
Syntax
Description
Parameters
C
OMMANDS
P
ARAMETERS
{hops <value 1-16> | time <sec 0-65535>}
<ipif_name 12> <ipaddr>
<ipif_name 12> <ipaddr>
string <mutiword 255> relay <ipaddr> [exact-match|partial-match]
[string <mutiword 255> {relay <ipaddr>} |ipaddress <ipaddr>| all
|default {<ipaddr>}]
{[string<mutiword 255>| ipaddress <ipaddr>| default]}
[relay <ipaddr> |mode [relay|drop]]
[enable |disable]
[mac_address <macaddr> |string <desc_long 255>] [relay <ipaddr>|
drop]
[mac_address <macaddr> | string <desc_long 255>|all]
[relay <ipaddr>|drop]
[enable|disable]
[enable | disable]
[enable | disable]
[default | user_define <desc 32>]
[replace | drop | keep]
{ipif <ipif_name 12>}
<value 1-32>
[add | delete] ipif <ipif_name 12> <ipv6addr>
[<ipif_name 12> |all] state [enable | disable]
{ipif <ipif_name 12>}
Used to configure the DHCP/BOOTP relay feature of the switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>}
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16> − Specifies the maximum number of relay agent hops that the
Page | 484