D-Link DGS-3700 Series Reference Manual page 391

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#config 802.1x fwd_pdu ports 1-2 enable
Command: config 802.1x fwd_pdu
Success.
DGS-3700-12:5#
show 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the 802.1X authentication state.
DGS-3700-12:5#show 802.1x auth_state ports
Command: show 802.1x auth_state ports
Status: A - Authorized; U - Unauthorized; (P): Port-Based 802.1X
Port MAC Address
---- -------------------- -------------- ------------- ------ ---- --------
CTRL+C ESC q Quit
To display the 802.1X configurations:
DGS-3700-12:5#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
Port Number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60
TxPeriod : 30
SuppTimeout : 30
ServerTimeout : 30
MaxReq : 2
ReAuthPeriod : 3600
ReAuthenticate : Disabled
Forward EAPOL PDU On Port : Disabled
Max Users On port : 128
DGS-3700-12:5#
config 802.1x capability
Purpose
Syntax
ports 1-2 enable
Used to display the 802.1X state or configurations.
show 802.1x [auth_state | auth_configuration] {ports <portlist|all>}
This command is used to display the 802.1X state or configurations.
auth_state − Used to display 802.1X authentication state machine of some or all ports
auth_configuration − Used to display 802.1X configurations of some or all ports.
portlist − Specifies a range of ports to be displayed.
all − Specifies all of ports to be displayed
None.
PAE State
SPACE n Next Page
sec
sec
sec
sec
times
sec
Used to configure the port capability.
config 802.1x capability ports [<portlist>|all] [authenticator|none]
Backend State Status VID Priority
p Previous Page r
Page | 391
Refresh