D-Link DGS-3700 Series Reference Manual page 421

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#show authen server_group
Command: show authen server_group
Server Group : mix_1
Group Name IP Address
--------------- --------------
mix_1
radius
tacacs
tacacs+
xtacacs
Total Entries : 5
DGS-3700-12:5#
config authen parameter response_timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the response timeout for 60 seconds:
DGS-3700-12:5# config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DGS-3700-12:5#
config authen parameter attempt
Purpose
Syntax
Description
Parameters
Protocol
--------
10.1.1.222 TACACS+
10.1.1.223 TACACS
10.1.1.224 RADIUS
10.1.1.225 TACACS
10.1.1.226 TACACS+
10.1.1.227 XTACACS
Used to configure the amount of time the Switch will wait for a user to enter
authentication before timing out.
config authen parameter response_timeout <int 0-255>
This command will set the time the Switch will wait for a response of authentication
from the user.
response_timeout <int 0-255> − Set the time, in seconds, the Switch will wait for a
response of authentication from the user attempting to log in from the command
line interface or telnet interface. Zero means there won't be a time-out. The default
value is 0 seconds.
Only Administrator-level users can issue this command.
Used to configure the maximum number of times the Switch will accept
authentication attempts.
config authen parameter attempt <int 1-255>
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of
attempts will be denied access to the Switch and will be locked out of further
authentication attempts. Command line interface users will have to wait 60 seconds
before another authentication attempt. Telnet users will be disconnected from the
Switch.
parameter attempt <int 1-255> − Set the maximum number of attempts the user may
try to become authenticated by the Switch, before being locked out. The default
setting is 3.
Page | 421