D-Link DGS-3700 Series Reference Manual page 345

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
C
OMMAND
show mgmt_pkt_priority
config per_queue bandwidth
_control
show per_queue bandwidth
_control
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure bandwidth control:
DGS-3700-12:5#config bandwidth_control 1-10 tx_rate 64
Command: config bandwidth_control 1-10 tx_rate 64
Success.
DGS-3700-12:5#
show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
P
ARAMETERS
{ports [<portlist> | all ]} <cos_id_list 0-7> {{min_rate [no_limit | <value
64-1024000>]} max_rate [no_limit | <value 64-1024000>]}
{<portlist>}
Used to configure bandwidth control on a port by-port basis.
config bandwidth_control [<portlist>| all] {rx_rate [no_limit | <value 64-
1024000>] | tx_rate [no_limit <value 64-1024000>]}
This command is used to configure bandwidth on a port by-port basis.
<portlist> − Specifies a port or range of ports to be configured.
rx_rate − Specifies that one of the parameters below (no_limit or <value 64-
1024000>) will be applied to the rate at which the above specified ports will be
allowed to receive packets
no_limit − Specifies that there will be no limit on the rate of packets received by the
above specified ports.
<value 64-1024000> − Specifies the packet limit, in Kbps, that the above ports will
be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or <value 64-
1024000>) will be applied to the rate at which the above specified ports will be
allowed to transmit packets.
no_limit − Specifies that there will be no limit on the rate of packets received by the
above specified ports.
<value 64-1024000> − Specifies the packet limit, in Kbps, that the above ports will
be allowed to receive.
Only Administrator and Operator-level users can issue this command.
Used to display the bandwidth control table.
show bandwidth_control {<portlist>}
This command is used to display the current bandwidth control configuration on the
Switch, on a port-by-port basis.
<portlist> − Specifies a port or range of ports to be viewed.
None.
Page | 345