D-Link DGS-3700 Series Reference Manual page 329

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
delete ipif
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an IP interface.
DGS-3700-12:5#delete ipif
Command: delete ipif if2
Success.
DGS-3700-12:5#
To delete an IPv6 address from the interface:
DGS-3700-12:5#delete ipif if2 ipv6address 5001::3700/8
Command: delete ipif if2 ipv6address 5001::3700/8
Success.
DGS-3700-12:5#
enable ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the admin state of one interface.
DGS-3700-12G:5#enable ipif System
Command: enable ipif System
Success.
DGS-3700-12G:5#
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
This command is used to delete an interface, all interfaces, or the IPv6 address of the
interface.
Note that the system interface can not be deleted. By using this command, an IPv6
address can be deleted from the IP interface.
<ipif_name 12> − The name of the deleted IP interface.
ipv6address – The IPv6 address which will be deleted from the IP interface.
all – Specifies that all the information will be deleted from the IP interface.
Only Administrator and Operator-level users can issue this command.
if2
Used to enable an IP interface on the switch.
enable ipif [<ipif_name 12> | all]
This command is used to enable the state for an IPIF.
When the state is enabled, the IPv4 processing will be started. When the IPv4 address
is configured on the IPIF. The IPv6 processing will be started when the IPv6
address is explicitly configured on the IPIF.
<ipif_name 12> − The name of the IP interface.
all – All the interface
Only Administrator and Operator-level users can issue this command.
Page | 329