D-Link DGS-3700 Series Reference Manual page 41

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
debug show status
Syntax
Description
Parameters
Restrictions
Example usage:
To show the specified module's debug state such as MSTP:
DGS-3700-12:5#debug show status module MSTP
Command: debug show status module MSTP
Debug Global State
MSTP
DGS-3700-12:5#
To show the debug state:
DGS-3700-12G:5#debug show status
Command: debug show status
Debug Global State
MSTP
IMPB
ERPS
DGS-3700-12G:5#
debug stp clear counter
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To clear all STP counters on the switch:
DGS-3700-12:5#debug stp clear counter
Command: debug stp clear counter
Success.
DGS-3700-12:5#
debug stp config ports
Purpose
Syntax
debug show status {module <module_list>}
This command is used to display the debug handler state and the specified module's
debug status. If the input module list is empty, the states of all registered modules
which support the debug module will be displayed.
module <module_list> - Specify the module list.
Only Administrator-level users can issue this command.
: Enabled
: Disabled
: Enabled
: Disabled
: Disabled
: Disabled
To clear the STP counters.
debug stp clear counter {ports [<portlist> | all]}
This command is used to clear the STP counters.
ports <portlist> | all] - Specify the port range.
Only Administrator and Operator-level users can issue this command.
To configure the per-port STP debug level.
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state
[disable | brief | detail]}
Page | 41