D-Link DGS-3700 Series Reference Manual page 285

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
disable qinq
All dynamically learned L2 address will be cleared. All dynamically registered VLAN
All existed SP-VLAN will run as static 1Q VLAN.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable Q-in-Q:
DGS-3700-12:5#disable qinq
Command: disable qinq
Success.
DGS-3700-12:5#
show qinq
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show global Q-in-Q status:
DGS-3700-12:5#show qinq
Commands: show qinq
QinQ Status: Enabled
DGS-3700-12:5#
show qinq ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show double tagging mode for ports 1-4 of unit 1:
entries will be cleared. GVRP will be disabled. If you need to run GVRP on the
switch, you shall enable GVRP manually.
Used to show global Q-in-Q.
show qinq
This command is used to show the global Q-in-Q status.
None.
None.
Used to show port's attributes in Q-in-Q mode.
show qinq ports {<portlist>}
This command is used to show the Q-in-Q configuration for a port, include:
• port role in Q-in-Q mode,
• enable/disable to drop the SP-VLAN assignment miss packet, port outer TPID,
and
• enable/disable use inner priority, add inner tag's configuration.
portlist − Specifies a range of ports to be displayed.
If no parameter specified, system will display all ports information.
None.
Page | 285