D-Link DGS-3700 Series Reference Manual page 335

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config loopdetect ports
Parameters
Restrictions
Example usage:
To set the loop-detect state to enable:
DGS-3700-12:5#config loopdetect ports 1-5 state enabled
Command: config loopdetect ports 1-5 state enabled
Success
DGS-3700-12:5#
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loop-back detection on the switch:
DGS-3700-12:5#enable loopdetect
Command: enable loopdetect
Success
DGS-3700-12:5#
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable loop-back detection on the switch:
DGS-3700-12:5#disable loopdetect
Command: disable loopdetect
Success
DGS-3700-12:5#
<portlist> − Specifies a range of ports for the loop-back detection
all – Specifies all the ports used for the loop-back detection.
state [enabled | disabled] – Allows the loop-back detection to be disabled and
enabled.
Only Administrator and Operator-level users can issue this command.
Used to globally enable loop-back detection on the switch.
enable loopdetect
This command is used to globally enable loop-back detection on the switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to globally disable loop-back detection on the switch.
disable loopdetect
This command is used to globally disable loop-back detection on the switch.
None.
Only Administrator and Operator-level users can issue this command.
Page | 335