Create 802.1X Guest_Vlan; Config 802.1X Guest_Vlan - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#config 802.1x authorization attributes radius enable
Command: config 802.1x authorization attributes radius enable
Success.
DGS-3700-12:5#

create 802.1x guest_vlan

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a previously created VLAN as a 802.1X Guest VLAN for the Switch.
DGS-3700-12:5#create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DGS-3700-12:5#
config 802.1x guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ports for a previously created 802.1X Guest VLAN as enabled.
Used to configure a pre-existing VLAN as a 802.1X Guest VLAN.
create 802.1x guest_vlan <vlan_name 32>
This command is used to configure a pre-defined VLAN as a 802.1X Guest VLAN.
802.1X Guest VLAN clients are those who have not been authorized for 802.1X or
they haven't yet installed the necessary 802.1X software, yet would still have
limited access rights on the Switch.
<vlan_name 32> − Enter an alphanumeric string of no more than 32 characters to
define a pre-existing VLAN as a 802.1X Guest VLAN. This VLAN must have first
been created with the create vlan command mentioned earlier in this manual.
Only Administrator and Operator-level users can issue this command.
The VLAN is supported for both port-based 802.1X and mac-based 802.1X and must
have already been previously created using the create vlan command. Only one
VLAN can be set as the 802.1X Guest VLAN.
Used to configure ports for a pre-existing 802.1X guest VLAN.
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
This command is used to configure ports to be enabled or disabled for the 802.1X
guest VLAN.
<portlist> − Specify a port or range of ports to be configured for the 802.1X Guest
VLAN.
all – Specify this parameter to configure all ports for the 802.1X Guest VLAN.
state [enable | disable] – Use these parameters to enable or disable port listed here as
enabled or disabled for the 802.1X Guest VLAN.
Only Administrator and Operator-level users can issue this command.
The VLAN is supported for both port-based 802.1X and mac-based 802.1X and must
have already been previously created using the create vlan command. If the
specific port state changes from an enabled state to a disabled state, these ports will
return to the original VLAN.
Page | 395