D-Link DGS-3700 Series Reference Manual page 101

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#show lldp ports 1
Command: show lldp ports 1
Port ID
--------------------------------------------------------------
Admin Status
Notification Status
Advertised TLVs Option
Port Description
System Name
System Description
System Capabilities
Enabled Management Address
(None)
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
DGS-3700-12:5#
config lldp_med fast_start repeat_count
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a LLDP-MED fast start repeat count of 5:
DGS-3700-12:5#config lldp_med fast_start repeat_count 5
Command: config lldp_med fast_start repeat_count 5
Success.
DGS-3700-12:5#
config lldp_med log state
Purpose
Syntax
Description
Parameters
: 1
: TX_and_RX
: Disabled
:
To configure the LLDP-MED fast start repeat count.
config lldp_med fast_start repeat_count <value 1-10>
Use this command to configure the fast start repeat count. When an LLDP-MED
Capabilities TLV is detected for an MSAP identifier not associated with an existing
LLDP remote system MIB, the application layer shall start the fast start mechanism
and set the 'medFastStart' timer to 'medFastStartRepeatCount' times 1. The default
value is 4.
<value 1-10> - Specify a fast start repeat count value between 1 and 10. The default
value is 4.
Only Administrator and Operator-level users can issue this command.
To configure the log state of LLDP-MED events.
config lldp_med log state [enable | disable]
Use this command to configure the log state of LLDP-MED events.
enable - Enable the log state for LLDP-MED events.
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Page | 101