D-Link DGS-3700 Series Reference Manual page 102

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config lldp_med log state
Restrictions
Example usage:
To enable the log state of LLDP-MED events:
DGS-3700-12:5#config lldp_med log state enable
Command: config lldp_med log state enable
Success.
DGS-3700-12:5#
config lldp_med notification topo_change ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable topology change notification on ports 1 to 2:
DGS-3700-12:5#config lldp_med notification topo_change ports 1-2 state enable
Command: config lldp_med notification topo_change ports 1-2 state enable
Success.
DGS-3700-12:5#
config lldp_med ports
Purpose
Syntax
Description
Parameters
disable - Disable the log state for LLDP-MED events. The default is disabled.
Only Administrator and Operator-level users can issue this command.
To enable or disable topology change notification.
config lldp_med notification topo_change ports [<portlist> | all] state [enable |
disable]
Use this command to enable or disable each port for sending topology change
notification to configured SNMP trap receiver(s) if an endpoint device is removed
or moved to another port. The default state is disabled.
<portlist> - Specify a range of ports to be configured.
all - Specify to set all ports in the system.
state – See below.
enable - Enable the SNMP trap notification of topology change detected.
disable - Disable the SNMP trap notification of topology change detected. The
default notification state is disabled.
Only Administrator and Operator-level users can issue this command.
To enable or disable transmitting LLDP-MED TLVs.
config lldp_med ports [<portlist> | all] med_transmit_capabilities [all |
{capabilities | network_policy | inventory}] state [enable | disable]
Use this command to enable or disable transmitting LLDP-MED TLVs. It effectively
disables LLDP-MED on a per-port basis by disabling transmission of TLV
capabilities. In this case, the remote table's objects in the LLDP-MED MIB
corresponding to the respective port will not be populated.
<portlist> - Specify a range of ports to be configured.
all - Specify to set all ports in the system.
med_transmit_capabilities - Select to send the LLDP-MED TLV capabilities
specified.
Page | 102