D-Link DGS-3700 Series Reference Manual page 524

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:4# disable cfm
Command: disable cfm
Success.
DGS-3700-12:4#
config cfm ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure CFM ports:
DGS-3700-12:5#config cfm ports 2-5 state enable
Command: config cfm ports 2-5 state enable
Success.
DGS-3700-12:5#
show cfm ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display CFM ports:
Used to enable or disable CFM function on per-port basis.
config cfm ports <portlist> state [enable | disable]
By default, CFM function is disabled on all ports.
If CFM is disabled on a port:
MIPs are never created on that port.
MEPs can still be created on that port, and the configuration can be saved.
MEPs created on that port can never generate or process CFM PDUs. If the user
issues a Loop-back or Linktrace test on those MEPs, it will prompt user that The
MEP does not exist.
ports – Specifies the logical port list.
state – Is used to enable or disable CFM function.
Only Administrator and Operator-level users can issue this command.
This command is used to show cfm state of specified ports.
show cfm ports <portlist>
This command is used to display CFM state of speicified ports.
ports – Specifies the logical port list.
None.
Page | 524